Yes, you & Seth were the the ones I followed doing this!

What is the part number for the wilwood proport valve?

79 Monte Carlo Calipers No E brake
Is that front or Rear?
Where can I get the Bracket from?
Thanks

I ordered mine from , www.speedwaymoters, 800-979-0122,is purple with a stick on it ,clean all off & it is a Wilwood.
Part number # 910-31355, $32.99

Where can I get the caliper brackets?
Skybrake.com has no listing
Downeyofforad.com is out of business
Any ideas?
Thanks

Try this site www.ruffstuffspecialties.com
I ordered the ones from Sky brake,wouldn't work with the Mustang rotors ,are for G.M. rotors,so made my own!

Called ruffstuff today
they dont make ones for the GM calipers
The brackets they make use tacoma calipers and stock front rotors
The guy on the phone said i can use my stock front calipers and rotors
That would be awsome cause i dont need them anymore
Now I just need to find drilled and slotted stock rotors

LC Engineering should have them.
Here's the place I got the Mustang rotors from,good prices & no different in quality than other brands.
brakeplanet.com.
Just went to this site,they have Power Slot drilled rotors $67 ea. ,no slots

What master did you use that is 1" ?
Does it bolt up to the stock booster?
Where did you get those rotors?
They are Mustang SVO front rotors?
What Calipers are you using?
I dont need Ebrake
Thanks in advance

Miss print ( too many beers),believe the unit is 1 1/8", not 1"
Stock one is 7/8"

I want those rotors you have where can I get them? Are they 11in?
Mustang SVO right?
No mods needed correct?
And what calipers did you use Caddy what year?
I dont need ebrake
Thanks in advance
Todd

Does anyone have the rear caliper bracket drawn in cad that I can have someone cut for me? I am intrested in the swap and have a 89 rear axle on my nissan and want to do the big brake setup on the front and want to do disc in the rear also...

Go to the original post I made when I first did this,all the info is there.
If you can't find it e-mail me & I'll send !
No on drawing ,but have the pattern I used ,part was plasma cut from 3/8" mild steel, & I ground to shape & machined as needed!

Size is 11.32'', got through brakeplanet.com,fit right on axle ,once backing plate & drum are removed.
Replace seals & bearings while there & longer wheel studs my be needed( HAVE SAME LENGTH AS STOCK )!!! Calipers through classicperformanceproducts.com:mrgreen:

I think I found what I need
check this out
http://www.tsmmfg.com/2494.htm
These brackets use either the monte carlo caliper (no ebrake) or the eldorado caliper (with ebrake)

My only problem is they list these brackets for a 4wd truck only
I am assuming a I can use these brackets as long as my axle spacing is the same as the 4wd which is 3 7/16 square bolt hole to bolt hole. does anyone know if the 2wd axle measurements are the same?
Last question would be on the rotor they list use of a 11 9/16 GM six lug rotor which once again you only fit a 4wd truck
If the mustang rotor measures the same diameter or smaller it should work

Any input guys?