i need to get my hands on a header that is higher than the bottom of my frame. what are my options and which companies do i consider. keeping in mind that horse power is an added bonus. thx

doug thorley headers are nice. i got mine ceramic coated so it wont discolor under intense heat.

oh and it stays above the frame....

ive also heard that the lc engineering headers although nice, still hang below the frame rails.

looks good what kind of price...in cdn funds?

i paid around $350 USD for it here in the states. but it did cost more because i had it ceramic coated. you can get a chrome one thats cheaper...its the same header but with chrome on it, it will discolor under the heat. i didnt want mine to discolor so i paid the extra.

i just coverted it, it comes out to approximately $387.06 (COD)

WTF where did my post go?

Well this is about what I posted yesterday.


'm running a Doug Thorley header. I love it. Its about 1/2" above the frame with my motor dropped one inch and layin flat. LC also makes a header that comes in two pieces that you just don't use the second piece on. I don't remember the cost on the LC. But my Thorley was $200 shipped.

where is every one getting the headers from? they look nice.

From Doug Thorley..

here's their website:

http://www.dougthorleyheaders.com/

Yes, LC's hang lower, & Doug Thorley's doesn't have one that fits with a manuel trans!!

i have one that fits mine. so does seth.

or do you mean not fitting an automatic trans?

so 4 months later, these headers are much more expensive....

$351.00 ???? Why? Am I missing something here?

http://www.dougthorleyheaders.com/produ ... 4/sfID2/35

On the old site it stated would not clear the clutch master cyl. on 5 speeds models . I would call before ordering.